Original Illustrated Factory Operating Instructions (User Manual) for Linde Electric Stacking Truck Type 379.

Original factory manuals for Linde Forklift Trucks, contains high quality images, circuit diagrams and instructions to help you to operate and repair your truck

Covered models:
L10 SN before R03973
L12 SN before R03973

Format: ZIP, Included:
Operating Instructions, PDF, 56 Pages
Additional operating instructions, PDF, 15 Pages

Language: English

Contents:

Description
Plates and labels
Technical data
Technical description
General view L 10 - L 12
Controls L10 - L12
Indicators
Combined hour meter
Discharge limiter indicator
Operation / Daily checks and maintenance prior to operation
Safety rules
Safety information
Handling lubricants
Advice for initial use
Checks before initial operation
Daily checks before use
Check the Forward/Reverse and raise/lower controls
Check the safety braking
Check the L12 automatic braking
Check emergency isolator operation
Check operation of horn
Check the battery state of charge
Open the battery cover with vertical outlet
Connect/disconnect the battery
Charge the battery with the integrated charger
Faults during charging
Remove the mains power supply cord
Charger electrical data
Special case of gelled batteries
Recharging the battery with anexternal charger
Check the condition of cables, terminals and battery contact
Check level of electrolyte and water supplement
Check the electrolyte gravity
Remove/replace the battery
Chang the battery with the help of a hoist
Operation L10 - L12
Instructions for use
Marking the travel direction
Start-up
Driving
Forward travel
Reverse travel
Direction of travel reversal
Steering
Safety reverser
Emergency stop button
Operating the truck on ramps
Ascending slopes
Descending slopes
Starting on a slope
Use
Mechanical braking
Braking by reversing the direction of motion
Parking brake
L.B.C. (Linde Brake Control) automatic braking
Horn control
Use of the mast
Use of the mast
Chassis lifting controls for L10 - L12
Tiller lifting controls for L10 - L12
Tiller lifting controls for L10Premier
Handling loads
Capacities L10 - L12
Reading the load diagram L10 - L12
Picking up a load on the ground
Transporting a load
Putting down the load on the ground
Stacking a load
Picking up a load at a height
Before leaving the truck
Slinging, towing and removing the mast
Slinging the truck
Raising the order picker
Towing
Removing the mast
Transporting and storing the truck
Maintenance
General remarks
Work on the lifting mast
Simplex lifting mast
Safety device for the Simplex lifting mast
Standard lifting mast
Safety device for the Standard lifting mast
Duplex lifting mast
Safety device for the Duplex lifting mast
Checks and maintenance work after the first 50 hours of service
Schedule of maintenance operations
Maintenance as required
Cleaning the truck
Opening the front cover
Releasing the flexible cover to access reduction gear unit and motor
Cleaning the battery and battery compartment
Battery in sealed case
Fuse check
Maintenance every 500 hours
Checking hydraulic circuit sealing
Checking hydraulic oil level
Replacing traction motor brushes
Cleaning the electrical plate and checking the electrical connections
Cleaning and checking contact wear
Checking the condition of cables, terminals and battery contact
Checking the incorporated charger
Checking the electrolyte level and density
Adjusting the height of the stabiliser wheel
Checking the condition and fixing of the mast and chains
Checking the mast protections
Adjusting the length of mast chains
Check the condition and fixing of wheels
Checking and controlling the brake controls
Checking the transmission belt status
Checking articulations
Cleaning and greasing the mast and chains
Maintenance every 1000 hours
Cleaning the hydraulic filter and breather
Replacing pump motor brushes
Checking the mechanical fixing of components
Maintenance every 2000 hours
Replacing the hydraulic oil
Recommended lubricants/ Technical data
Hydraulic diagrams
Electrical diagrams
Index.