Mitsubishi Grandis 2004-2008 Factory Service & Shop Manual
Complete workshop & service manual with electrical wiring diagrams for Mitsubishi Grandis 2004-2008. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Mitsubishi Grandis 2004-2008 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

EXCERPT:
00 General
00E General < Electrical >
11A Engine Mechanical
11B Engine Overhaul
12 Engine Lubrication
13A Multiport Fuel Injection (MPI)
13B Fuel Supply
14 Engine Cooling
15 Intake and Exhaust
16 Engine Electrical
17 Engine and Emission Control
21A Clutch
21B Clutch Overhaul
22A Manual Transmission (FF)
22B Manual Transmission Overhaul
23A Automatic Transmission (FF)
23B Automatic Transmission Overhaul
26 Front Axle
27 Rear Axle
31 Wheel and Tyre
32 Power Plant Mount
33 Front Suspension
34 Rear Suspension
35A Basic Brake System
35B Anti-Skid Braking System (ABS)
35C Traction Control / Active Stability Control System
36 Parking Brakes
37 Power Steering
42 Body
51 Exterior
52A Interior
52B Supplemental Restraint System (SRS)
54A Chassis Electrical
54B Smart Wiring System (SWS) not Using SWS Monitor
54C Smart Wiring System (SWS) Using SWS Monitor
54D Controller Area Network (CAN)
55 Heater, Air Conditioner and Ventilation
70 Component Locations
80 Configuration Diagrams
90 Circuit Diagrams
…
CLUTCH DISC
CAUTION
Don't clean the clutch disc in a cleaning solvent.
1. Check the facing for loose rivets, uneven contact, evidence of seizure, or deposited oils and greases. If defective, replace the clutch disc.
NOTE: If contaminated with grease or oil, determine the source of the contaminant and repair it.
2. Measure the rivet sink. Replace the clutch disc if it is below the limit.
Minimum limit: 0.3 mm
3. Check the torsion spring for play and damage. If defective, replace the clutch disc.
4. Place the clutch disc on the input shaft and check for sliding condition and play in the rotating direction. If poor sliding condition is evident, clean, reassemble, and recheck.
If excessive play is evident, replace the clutch disc and/or input shaft.
CLUTCH RELEASE BEARING CAUTION
Release bearing is packed with grease.
Therefore, do not wash it in a cleaning solvent.
1. Check for seizure, damage, noise or binding/rough rotation.
2. Check for wear on the surface which contacts with the diaphragm spring.
3. Check for wear on the surface which contacts with the release fork. If abnormally worn, replace.
RELEASE FORK
If the surface which contacts with the bearing is abnormally worn, replace.
…